How much does it cost to have a shower?
Work out what it costs to heat water — a bath, a shower, a sink or a full cylinder — on your own electricity rate, including what an insulated tank loses while it just sits there.
Using the German average of 38.69c/kWh — Eurostat, the second half of 2025.
Eight minutes at eight litres a minute. A power shower can push twice that flow, which doubles the cost for the same eight minutes.
Common cases
What drives the cost
A shower's cost is flow rate multiplied by time, and flow rate varies far more between showers than people realise. A restricted eco head might deliver six litres a minute, a normal mixer eight to ten, and a power shower fifteen or more. Two households taking identically long showers can differ threefold in cost.
That makes the shower head the cheapest intervention available here. Swapping a high-flow head for an aerating one typically cuts water use by a third with little perceptible difference, and it saves the same proportion of the heating energy every single shower thereafter.
How this is worked out
Heating water takes a fixed amount of energy that depends only on how much water there is and how far you are raising its temperature. It takes 4.186 kilojoules to lift one kilogram of water by one degree, a litre weighs about a kilogram, and a kilowatt hour is 3,600 kilojoules — so one litre raised by one degree needs 0.00116 kWh. Multiply by your litres, by the temperature rise, and by your unit rate, and that is the cost. Nothing about this changes from country to country; only the price does.
What this assumes
- Cold water enters at the temperature you set. Mains temperature swings from about 10 °C in winter to nearly 20 °C in summer, so the same bath genuinely costs more in January than in July.
- All the heat ends up in the water. That is true for an immersion heater and close to true for a heat pump cylinder, but a gas boiler loses some up the flue.
- Standing loss is a flat daily figure. In reality it rises with the temperature difference, so a cylinder loses more in a cold house than a warm one.
- Efficiency above 100% means a heat pump, which is not a contradiction: it moves existing heat rather than creating it, so it delivers more heat than the electricity it consumes.
- The rate filled in for you is an average that spreads fixed charges across a year's usage, so it sits above what one extra unit really costs. Entering the unit rate from your own bill gives a closer answer.
Questions
How do I find my shower's flow rate?
Run it into a bucket for exactly one minute and measure what comes out in litres. That is the number to divide into your shower length — it is far more reliable than any manufacturer figure.
Why is 60 °C the usual setting?
Because legionella bacteria survive in stored water between roughly 20 and 45 °C and are killed reliably at 60. That is why cylinders are set there even though nobody uses water that hot — it gets blended with cold at the tap.
Is it cheaper to heat water only when I need it?
For a cylinder, usually yes, because a tank sat at temperature is losing heat continuously. Heating on a timer just before you need it cuts that loss. The exception is if it lets you heat on a cheap overnight rate, which normally beats the standing loss.
Does it cost less to heat water in summer?
Yes, and by more than most people expect. Mains water can arrive nearly 10 °C warmer in summer, which on a 50 degree rise is a fifth less energy for exactly the same tankful.
Does this work for gas water heating?
The energy figure does — the physics is the same. The cost does not, because you would need to enter a gas price per kWh and drop the efficiency to around 80–90% to account for flue losses. This tool is set up for electricity.
Related tools
Sources
- Engineering ToolBox — specific heat of water — checked 2026-08-21
- UK HSE — legionella and hot water temperature control — checked 2026-08-21
Rates from Eurostat for the second half of 2025. Last reviewed 21 August 2026.